15
7. OPERATING ENGINE
■
STARTING ENGINE
1.Fill fuel and chain oil tanks respectively, and tighten the caps
securely.(F7)
2.Put the switch to
“I” position.(F8)
3.While holding the throttle lever together with the throttle
interlock, push in the side throttle lock button and release the
throttle lever to hold it at the starting position.(F9)
(1)
Chain oil
(2)
Fuel
(3)
Switch
(4)
Throttle lock button
(5)
Throttle lever
(6)
Throttle interlock
(7)
Choke knob
4.Pull out the choke knob to the closed position.(F10)
When restarting immediately after stopping the engine,
leave the choke knob at the open position.
5. While holding the saw unit securely on the ground, pull the
starter rope vigorously.(F11)
Do not start the engine while hanging the chain saw with
a hand. The saw chain may touch your body.
It
’s very dangerous.
6.When engine has ignited first, push in the choke knob and
pull the starter again to start the engine
7.Allow engine to warm up with throttle lever pulled slightly.
Keep clear of saw chain - it will start rotating on starting engine.
■
CHECKING OIL SUPPLY
After starting the engine, run the chain at medium speed and
see if chain oil is scattered off as shown in the figure.(F12)