8
First use
Before first use, heat the empty appliance with
é
Steam
cooking for 20 minutes at 100 °C. Do not open the appliance
door during this time. The appliance is automatically calibrated
(see section: Automatic calibration).
1.
Press the operating mode selector so that it pops out.
The appliance switches on.
2.
Fill and insert the water tank (see section: Filling the water
tank).
Before using for the first time, moisten the seal in the tank
cover with a little water.
3.
Turn the operating mode selector round to
é
Steam
cooking.
4.
Press the Start button.
The appliance heats up to 100 °C. The cooking time
(20 minutes) does not start to count down until the set
temperature has been reached. Do not open the appliance
door during this time.
The cooking operation ends automatically and an audible
signal sounds.
5.
Press the
KJ
clock function button to exit the clock function.
6.
Turn the operating mode selector back to the
Û
position and
click in place to turn off the appliance.
Leave the appliance door ajar until the appliance has cooled
down.
Cleaning the accessories before use
Using soapy water and a soft cloth, clean the accessories
thoroughly before first use.
Operating the appliance
In this section, you can read about
■
how to fill the water tank
■
how to switch the appliance on and off
■
what to note after each cooking operation
Filling the water tank
When you open the appliance door, you will see the water tank
on the right-hand side.
Caution!
Use of unsuitable liquids may damage the appliance
■
Only use fresh tap water, softened water or uncarbonated
mineral water.
■
If your tap water is very hard, we recommend that you use
softened water.
■
Do not use distilled water, highly chlorinated tap water
(> 40 mg/l) or other liquids.
You can obtain information about your tap water from your
water supplier. The water hardness can be checked with the
test strips enclosed.
Fill the water tank before each use:
1.
Open the appliance door and take out the water tank.
2.
Fill the water tank with cold water up to the "max" mark.
3.
Close the tank cover until you feel it engage.
4.
Slide in the water tank until it engages.
Switching on the appliance
1.
Press the operating mode selector to make it pop out.
The appliance switches on. "Appliance is ready for use"
appears in the text display.
2.
Turn the operating mode selector until the desired operating
mode appears on the text display.
A default temperature appears on the temperature display.
3.
Turn the temperature selector to change the default
temperature.
For operating modes that use steam, a default cooking time
appears in the electronic clock. The
KJ
and
x
(cooking
time) symbols light up.
4.
Turn the rotary selector to change the default cooking time.
The new cooking time is saved automatically after 3 seconds.
You can also set the cooking time for operating modes that
do not use steam (see section: Electronic clock).
5.
Press the Start button.
If you do not press the Start button, a signal sounds and
"Press Start button" appears in the text display.
When
é
steam cooking, the cooking time does not start until
the heating up time has elapsed.
PD[
Operating mode
Temperature range
é
Steam cooking 35 - 100 °C
8
CircoSteam®
120 - 230 °C
3
Hot air
30 - 230 °C
ä
Reheat
100 - 180 °C
ê
Dough proving 35 - 50 °C
A
Defrost setting
35 - 60 °C
/
Low-tempera-
ture cooking
60 - 120 °C
P
Plate warming
30 - 70 °C
ç
Keep warm
60 - 100 °C
6WHDPFRRNLQJ
