NEFF B46E74.3GB, Instruction Manual

Page: 30 / 32

30
3.
Replace the oven light bulb with a bulb of the same type.
4.
Screw on the glass cover again.
5.
Remove the tea towel and switch on the circuit breaker.
Note:
If the glass cover cannot be unscrewed: use rubber
gloves to turn it. You can order a special removal tool through
the after-sales service (order no. 613634)
Changing halogen bulbs
Spare bulbs can be obtained from the after-sales service or
specialist retailers. Verwenden Sie nur diese Halogenlampen:
Osram HALOSTAR ECO, 12 V, GY 6.35, 25 W
:
Risk of burns!
Halogen bulbs become very hot when switched on. When
replacing them, wait until the bulb has cooled down.
Caution!
Clouding in halogen bulbs: Do not touch halogen bulbs with
bare fingers. This causes oils to get onto the glass which are
then burnt on and cloud the glass. Use a clean cloth to change
the bulb.
1.
Remove the appliance door (see section: Removing and
refitting the appliance door).
2.
Remove the door panel (see section: Cleaning the door
panels).
3.
Defekte Halogenlampe zusammen mit der Lampenfassung
aus der Halterung ausrasten und vorsichtig aus dem
Reflektor herausnehmen.
4.
Defekte Halogenlampe aus der Lampenfassung
herausziehen (Bild A).
5.
Neue Halogenlampe in die Lampenfassung einsetzen.
Verwenden Sie hierfür ein sauberes Tuch (Bild B).
6.
Lampenfassung wieder in die Gerätetür einsetzen.
7.
Fit the door panel and appliance door.
Changing the door seal
If the door seal is defective, it must be replaced. Replacement
seals for your appliance can be obtained from the after-sales
service.
Unhooking the door seal
The door seal is fixed in nine places.
1.
Unhook (Fig. B) the door seal at four points (Fig. A).
2.
Hook the door seal in at five further points (Fig. C) by turning
the hooks slightly (Fig. D).
Hooking in the door seal
1.
Hook (Fig. B) the door seal in at four points (Fig. A).
2.
Hook the door seal in at five further points (Fig. C) by turning
it slightly (Fig. D).
3.
Check that the door seal is seated correctly.
After-sales service
Our after-sales service is there for you if your appliance needs
to be repaired. We will always find the right solution in order to
avoid unnecessary visits from a service technician.
E number and FD number
When calling us, please give the product number (E no.) and
the production number (FD no.) so that we can provide you with
the correct advice. The rating plate containing these numbers
can be found on the right-hand side of the oven door. You can
make a note of the numbers of your appliance and the
telephone number of the after-sales service in the space below
to save time should it be required.
Please note that there will be a fee for a visit by a service
technician in the event of a malfunction, even during the
warranty period.
Please find the contact data of all countries in the enclosed
customer service list.
% $
$ %
& '
E no. FD no.
After-sales service O