NEFF B46E74.3GB, Instruction Manual, Page: 27 / 32

27
Fitting the appliance door
1.
Hold the appliance door and raise the door handle slightly
with both thumbs (Fig. A).
2.
Fit the appliance door in the left and right-hand guide rollers
simultaneously (Fig. B).
3.
Ensure that the appliance door does not tilt unevenly and that
it is properly fitted in place (Fig. C).
4.
Use a coin to release both locks on the appliance door
(Fig. D).
Left lock: anti-clockwise
Right lock: clockwise
5.
Open the appliance door a little wider and then close it.
:
Risk of injury from hinge locks which have not been
properly closed!
The appliance door may detach itself. You may be injured
and the appliance door damaged. After refitting the door,
always close the left and right-hand hinge locks.
6.
Close the left and right-hand hinge locks (Fig. E).
To do this, push the hinge lock (Fig. F) fully downwards on
both sides with a screwdriver.
Cleaning the door panels
To facilitate cleaning, you can remove the door panels from the
appliance door.
:
Risk of injury!
The components inside the appliance door may have sharp
edges. Take care not to cut yourself. Wear protective gloves.
:
Risk of injury!
The appliance must not be used again until the door panels
and appliance door have been correctly fitted.
Removing the door panel
Note:
Before removing, make a note of which way round the
door panel is fitted, so that it is not refitted the wrong way
round.
1.
Unhook the appliance door and lay it on a soft, clean surface
with the front side facing downwards (see section: Removing
and installing the appliance door).
2.
Carefully lift the door panel slightly and remove it in the
direction of the arrow (fig. A).
Removing the intermediate panel
Note:
Before removing, make a note of the position in which
the intermediate panel is fitted, so that you do not refit it the
wrong way round later.
1.
Remove the seal. Pull seal outwards and remove upwards
(fig. B).
2.
Release and remove the retainer (fig. C).
3.
Lift the intermediate panel slightly and take it out (fig D).
Cleaning
Clean the door panels with glass cleaner and a soft cloth.
Caution!
Do not use any sharp or abrasive medium or a glass scraper.
The glass could be damaged.
Fitting the intermediate panel
Note:
During installation, make sure that the lettering "top right"
is upside down at the bottom left.
1.
Insert the intermediate panel towards the back as far as it will
go (fig. A).
2.
Hook in the seal on both sides (fig. B).
$ %
& '
) (
$
%
' &