VP1007-B / Installation manual
Version 01.000 / November 2020 / EN
7
Livestock Management
Notwithstanding all due precaution by Nedap, Nedap Animal Identification may not function optimally due
to devices that emit radio waves, such as (but not limited to) variable frequency drives, electronic ballasts of
lighting systems, power supplies, electronic converters of solar panels/windmills and (long) wave radio stations,
which may cause interference with Nedap Animal Identification.
No claims, representations or warranties, whether expressed or implied, are made by Nedap as to the
performance, reliability, durability and safety of Nedap Animal Identification used in conjunction with
abovementioned or other devices.
In order to achieve optimal performance of Nedap Animal Identification, the electrical installation on the farm
needs to meet the conditions that are shown below.
•
Maximum allowed environmental noise level: 10 dBµA/m quasi peak, according to CISPR 16-1-1.
•
Maximum allowed conducted noise: according to EN55032: 2015.
3.1.3 Tools requirements
•
Screwdriver size 0.4 x 2.5 mm (0.016 x 0.098 in.) for the LAN connector of the V-pack.
3.2 Mount the VP1007-B
Mount the VP1007-B in a dust and splash proof housing, preferably a Nedap V-box:
If the VP1007-B is installed as a part of a complete Nedap system, use the installation manual of this
system. The installation manual can be obtained from your dealer or on our Business portal:
www.nedap.com/livestockmanagement-portal
1. Mount the V-box according to the installation instructions of the V-box, which can be obtained from your
dealer or on our Business portal:
http://www.nedap.com/livestockmanagement-portal
.
2. Mount the VP1007-B in the V-box:
a. Pull down the 2 lips on the back side of the VP1007-B.
b. Place the VP1007-B on the top of the DIN rail inside the V-box.
c. Hinge down the VP1007-B until it clicks in.
d. Push up the 2 lips to secure the VP1007-B to the DIN rail.
3. Close the V-box.
Caution
Make sure to always close the V-box with the V-box cover and check the correct position of the cover
seal.
3.3 Wiring
Connectors
