NED
UME-0025-02 SU2025GIG
59
5.14 Saving and Loading Camera Settings
The camera setting data is saved in the internal memory (flash memory) and is
loaded from the memory when turning on the power supply or loading.
The number of times the flash memory can be rewritten will vary depending
on actual operational conditions. After turning on the power supply, the
camera always checks the memory status. If the data is not within the
designated range due to a malfunction or other type of trouble, the memory
will be automatically rewritten with the factory settings.
If disconnecting camera power while rewriting the memory, all data saved in
the memory will be deleted.
As it takes 5 seconds to rewrite the memory, do not disconnect the power
supply before receiving the response from the camera.
Commands for rewriting the memory are as follows.
Reset to factory settings
（
UserSet_ResetToFactoryDefault
）
Save to Memory
（
UserSet_Save
）
Load from Memory
（
Userset_Load
）
When changing the camera Exposure Mode setting, be sure to send the control
input signal from the
Trigger
Controller. If you do not send CC1 or send control
input signals are out of the designated range, you cannot get images and cannot
change the settings. See 5.2 to 5.7.
