NED
RMSL6K17GE
UM-0099-03
20
3.3 Power Supply Connection
6 pin round shape push-pull lock type connector for Power supply.
The pin assignment of the power supply connector is shown below.
Figure 3-3-1 Power Supply Connector (HR10G-7R-6PB
）
Table 3-3-1 Pin Assignment of Power Supply Connection
No
NAME
Color of Cable
No
NAME
Color of Cable
1
DC12
～
15V
White
4
GND
Green
2
DC12
～
15V
Red
5
GND
Black
3
DC12
～
15V
NC
6
GND
NC
The camera requires a single power supply (DC+12 to +15V).
When selecting a power source, choose one with the capacity to allow for
in-rush current. (15W or more recommended)
Insert the cable plug securely until it locks into position. This is to prevent the
connector from coming loose during power transmission.
Do not remove the cable while image data is being transmitted
Compatible Cable (Compatible plug):
DGPSH -10 (HIROSE : HR10A -7P - 6S)
Power supply voltage:
DC+12 -15V (+/-5%)
Consumption Current (rated):
DC+12V : 500mA
If the lamp fails to illuminate even after power is switched on, turn off power
immediately. Inspect wiring. Check the voltage and capacity of the supplied power
source.
Provide a lightning surge protector on the power supply line for the camera used in
the region where the possibility of thunder becomes high.
Do not share the power supply and ground connection with the apparatus such as
the inverter controlled motor units or other devices that generate noise interference
to avoid the failure and malfunction of the camera. Place the camera far away from
the apparatus generating noise. Do not arrange the signal cables and the power
supply cable for camera adjacently.
1
2
3
6
5
4
