NED
RCDL4K8GE
UME-0111-01
72
Trigger Mode : On
(See section 4.2.4.3)
Remark: The above settings can be saved. (See section 4.2.
8.3 “Setting
Memory Saving”)
4.3.2 Two-phase Trigger setting (for Example)
This is the setting procedure
in the case that “LineIn1” and “LineIn2” as
“Line Selector” and “HighResolution” as “Encoder Mode” are used.
①
Setting No-Permission before using External Trigger
After selecting “Trigger Selector“ in the categories of “Acquisition Control”,
set as follows.
Trigger Selector : Exposure Start (See section 4.2.4.2)
Trigger Mode : Off
(See section 4.2.4.3 but set
“Off” at this time)
Note: Do not skip the step
①
above, otherwise the wave pattern and
the image may not be output properly.
②
Setting External Trigger Signal Format
(LineIn1/ LineIn2/ LineIn3) and
(TTL/RS422NotTerminate/RS422Terminate/LVDS)
Set this according to sections 4.2.6.1 and 4.2.6.5.
This setting is not required if the existing setting remains.
③
Selecting External Trigger Signal Type for Encoder Source A
(LineIn1)
After selecting
“Encoder Source A” in the category of “Encoder Control”,
set as follows.
(Example) LineIn1
Encoder Source A: LineIn1
See section 4.2.7.2
④
Selecting External Trigger Signal Type for Encoder Source B
After selecting “Encoder Source B” in the category of “Encoder Control”,
set as follows.
(Example) LineIn2
Encoder Source B: LineIn2
See section 4.2.7.3
