NED
UME-0111-01
RCDL4K8GE
71
4.3 Setting Procedure of External Trigger Settings (for Examples)
4.3.1 One-phase Trigger setting (for Example)
This is the setting procedure
in the case that “LineIn3” as “Line Selector” and
“TTL” as “Line Format” are used.
①
Setting No-Permission before using External Trigger
After selecting
“Trigger Selector“in the categories of “Acquisition Control”,
set as follows.
Trigger Selector : Exposure Start (See section 4.2.4.2)
Trigger Mode: Off
(See section 4.2.4.3 but set “Off” at this time)
Note: Do not skip the step
①
above, otherwise the wave pattern and
the image may not be output properly.
②
Setting
“Line Selector” and “Format” of External Trigger Signal
(LineIn1/ LineIn2/ LineIn3)
(TTL/RS422NotTerminate/RS422Terminate/LVDS)
After selecting
“Line Selector“in the categories of “Digital IO Control”,
(Example)
“LineIn3” and “TTL”
Line Selector : LineIn3
(See section 4.2.6.1)
Line Format : TTL
(See section 4.2.6.5)
Remark: Other External Trigger Signal format can be set on the remaining
selection of
“Line Selector”. These settings can be saved
in selectio
n of “Line Selector” respectively.
③
Selecting External Trigger Signal Type
External Trigger Signal Type can be set below.
After selecting
“Trigger Sourcer” in the categories of “Acquisition Control”,
set as follows.
(Example)
“LineIn3” and “Rising Edge”
Trigger Source : LineIn3
Trigger Activation : Rising Edge
④
Setting Permission before using External Trigger Setting
After selecting “Trigger Mode” in the categories of “Trigger Selector”,
set as follows.
