Necta Necta Colibri Espresso, Installation, Use And Maintenance Manual

Page: 23 / 47

20
© by NECTA VENDING SOLUTIONS SpA 09-2003 228 00
INITIALISING
When the “Initialising” function is displayed the vending
machine can be initialized restoring all default data.
This function should be used if there is a memory data
error or when the EPROM is replaced.
All statistic information will be reset.
Press confirm button “ ” and the display will indicate the
message “Confirm?”. Press the button “ ” again to display
the first variable parameter to define the machine configu-
ration.
The available options (blinking) can be scrolled with the
“ ” and “ ” buttons, the selection is confirmed with button
“ ” and the next parameter is presented. When pressing
button “ ” after the last parameter the display will show
the message “Working” for a few seconds and the ma-
chine is initialised.
The parameters are as follows:
“Machine type” C - Espresso
I - Instant
“Country” Type of doses to be
used for the selections
“Layout” Layout of containers and
selection menu from the
available ones
“Tank” Water supply from the mains
or from a tank
SETTING THE MACHINE CODE
When the “Machine code” function is displayed the iden-
tification code number of the machine can be changed
(from the default 0000 to 9999).
Press the confirm button “ ” and the current code number
is displayed; then press the change button “ ” and the first
digit will start blinking.
The value of the blinking digit can be increased or
decreased with the “ ” and “ ” buttons.
When pressing the confirm button “ ”, the blinking digit
will take on the displayed value and the next digit starts
blinking.
MACHINE CONFIGURATION
When the “Machine config” function is displayed, the
machine configuration can be changed, and namely:
- water supply from the mains (Tank OFF) / internal
tank (Tank ON)
- presence of warning device for full liquid waste
container (equipped cabinet ON)
- fast cycles ON / OFF (see following paragraph)
- coffee tray ON / OFF
Press the confirm button “ ” to display the current status;
when pressing the change button “ ” the status starts
blinking and can be changed with the “ ” and “ ” buttons.
IMPORTANT NOTICE!!!
When the machine is initialised, the configuration will
take on the default values: “Water supply from the
mains/without full waste container warning device/
fast cycles ON”.
AFTER INITIALISING THE MACHINE MUST BE
RECONFIGURED.