Necta Korinto UL, Installation, Use And Maintenance Manual

Page: 13 / 56

9
© by N&W GLOBAL VENDING SpA 07 06 274 -00
Chapter 2
INSTALLATION
Installation and the following maintenance operations
should be carried out with the
machine switched on
and
therefore by qualified personnel only, who are trained in
the correct use of the machine and informed about the
specific risks of such situation.
The machine is not suitable for outdoor installation, it must
be installed in a dry room where the temperature remains
between 2° C and 32° C.
The machine cannot be installed where water jets are used
for cleaning.
At installation the hydraulic circuits and the parts in
contact with foodstuff should be fully sanitised to
remove any bacteria which might have formed during
storage.
POWER SUPPLY SWITCHES
Main
A main switch is fitted outside the machine, disconnecting
the power from the machine without having to open the
door.
The terminal strip supporting the line cable, the fuses
and the noise suppressor stay energised in any case.
Door
When opening the door a special microswitch disconnects
the power from the machine electrical system.
To energize the system with the open door, simply insert
the special key into the slot (see Fig. 11).
Top panel
Also when opening the machine top panel, a switch
disconnects the power, allowing loading operations in a
safe condition.
The switch on key MUST NOT be left inside the ma-
chine, it must be kept by the qualified personnel
trained in the use of the machine.
With the door open, there is no access to energised
parts. Inside the machine, the only parts that stay
energised are those protected by covers and carrying
a plate with the warning “disconnect the power before
removing the protective cover”.
Before removing such covers disconnect the power
supply cable from the grid.
The door can be closed, and therefore the vending ma-
chine switched on, only after removing the yellow key from
door switch and closing the machine top panel.
UNPACKING THE VENDING MACHINE
After removing the packing, ensure that the machine is
intact.
If in doubt do not use the machine.
No packing elements (i.e. plastic bags, polystyrene
foam, nails, etc.) should be left within the reach of
children, as they are potentially dangerous.
Packing materials must be disposed of in authorised
containers and the recyclable ones must be recovered by
qualified companies.
Important notice!!
The machine should be positioned on a level surface.
A side module (optional) can be added to the machine to
enhance its performance.
Fig. 11
1 - Door switch
2 - Top panel switch and actuator
3 - Network fuses
4 - Main external switch
Fig. 12
1 - Side module
2 - Gasket