Necta Vending Solutions SpA Zeta CB Series, Installation - Use - Maintenance

Page: 6 / 40

© by NECTA VENDING SOLUTIONS SpA 01 10 126-03
42
IN CASE OF FAILURE
In most cases, any technical problems are corrected by
small repair operations; however, before contacting the
manufacturer we recommend that this manual be read
carefully.
Should there be more serious problems or malfunctions,
then contact the following:
NECTA VENDING SOLUTIONS SpA
Via Roma 24
24030 Valbrembo
Italy
Tel. +39 - 035606111
TRANSPORT AND STORAGE
To prevent any damage, special care should be taken when
loading or unloading the vending machine.
The machine can be lifted by a motor-driven or manual fork
lift truck, and the forks are to be placed underneath the
machine from the side clearly indicated by the symbol on
the cardboard package.
Do not:
- overturn the vending machine;
- drag the vending machine with ropes or similar;
- lift the vending machine by its sides;
- lift the vending machine with slings or ropes;
- shake or jolt the vending machine.
The machine should be stored in a dry room where the
temperature remains between 0 and 40° C.
USE OF THE CAN & BOTTLE
VENDING MACHINE
Can & bottle vending machines should only be used to sell
and dispense drinks contained in factory-sealed cans and
bottles made of different materials (such as metal, glass,
plastic. etc.).
Strictly comply with the manufacturer's specifications
regarding storage and expiry date for each product.
Any other use is incorrect and thus potentially dangerous.
INTRODUCTION
This technical documentation is a part and parcel of the
vending machine.
Therefore it must always follow the machine when it is
moved or ownership is transferred, so that different
operators may be able to consult it.
Before installing and using the machine, it is first necessary
to carefully read and understand the instructions contained
in this manual, as they offer important information for safe
installation, use and maintenance.
This manual is divided into three sections.
The first section describes the loading and routine cleaning
operations which are carried out in areas of the machine
accessible with the sole use of the door key, without using
any other tools.
The second section contains the instructions for correct
installation and all information necessary for optimum use
of the machine.
The third section describes the software programming.
The operations described in the second and third
sections must be carried out exclusively by personnel
who have a specific knowledge of the machine func-
tions from a point of view of electrical safety and health
regulations.
IDENTIFICATION OF THE VENDING
MACHINE AND ITS CHARACTERISTICS
Every machine is identified by its own serial number,
indicated on the rating plate attached inside the cabinet on
the right hand side.
This plate (see Figure 2) is the only one acknowledged by
the manufacturer as identification of the machine, and
carries all data which readily and safely gives technical
information supplied by the manufacturer. It also assists in
the spare parts management.
It is therefore recommended that this plate be neither
damaged nor removed.
Fig. 2
Absorbed power
Operating voltage
Product code
Corrente
Frequency
Serial
number
Model
Type
Refrigeration system
class
Type and amount of
refrigerant gas