Necta Vending Solutions SpA Zeta CB Series, Installation - Use - Maintenance

Page: 22 / 40

© by NECTA VENDING SOLUTIONS SpA 58
01 10 126-03
MDB interface
Decimal point position
Basic coin value
Time of cycle start
Motor safety time
(0 to 30 seconds)
Price of selection 10
Maximum credit
Price of selection 1
Maximum change
Multiple sales
Coin acceptance
Coin acceptance
1st digit of machine code
2nd digit of machine code
6th digit of machine code
Initialising
Counters display
To start programming press button 1, the message
will be displayed indicating the number of
selections for the machine.
If this is the desired number, press button 2 to go to the
next parameter, otherwise set the new value by using
button 3 to increase or button 4 to decrease (minimum 1,
maximum 10 columns), then press button 2 to store the
new data unit and go to the next parameter.
"x" is the number of selections.
It can be set to values varying from 1 to 10 (default = 6).
Type of payment system
CR 0 = Validators
CR 1 = Executive
CR 2 = MDB
CR 3 = Price holding
CR 4 = Coges
CR 5 = U-key
Value of basic coin.
"xx" must be given the value of the lowest coin denomina-
tion accepted by the coin mechanism. For Italy this value
is 50 (Lire), for other countries generally it is 10 (cents). In
"serial" operating mode, this information is transmitted
directly from the coin mechanism to the control board.
Time of cycle start
Motor safety time
(0 to 30 seconds)
1st digit of machine code
2nd digit of machine code
6th digit of machine code
Counters display
"Price Holding" interface
Basic coin value
Line/Price of selection 1
Line/Price of selection 10
Initialising