NEC SL1100, Programming Manual

Page: 159 / 666

Program 15 : Extension, Basic Setup
15-03 : Single Line Telephone Basic Data Setup
Level:
IN
Description
Use Program 15-03 : Single Line Telephone Basic Data Setup to set up various single line
telephone options.
Input Data
Extension Number Maximum four digits (SL1000)
Maximum eight digits (SL1100)
Item
No.
Item Input Data Description Default Related
Program
01 SLT Signaling
Type 0 = DP
1 = DTMF Use this option to tell the system the
type of dialing the connected tele-
phone uses.
For Analog Wireless telephones to
function correctly, this must be set
to 0 (dial pulse). If this option is set
for DTMF, after an outside call is
placed, the system cannot dial any
additional digits.
This program change is automatical-
ly performed when the Analog Wire-
less telephone is registered. When
upgrading software from prior ver-
sions, the previous default of 1 is
saved from the prior database so
this option must be changed man-
ually. 1 15-03-03
45-01-01
03 Terminal Type 0 = Normal
1 = Special Enter 1 for this option to allow a sin-
gle line port to receive DTMF tones
after the initial call setup. Enter 0 to
have the port ignore DTMF tones af-
ter the initial call setup. For Voice
Mail, always enter 1 (e.g., receive
DTMF tones). 0 15-03-01
45-01-01
04 Flashing 0 = No
1 = Yes Enables/disables Flash for single
line telephones. 1
05 Trunk Polarity
Reverse 0 = Off
1 = On Do Not Change Default Entry as
DTMF issues may arise with voice
mail. 0
06 Extension Polari-
ty Reverse 0 = Disable (Off)
1 = Enable (On) Do Not Change Default Entry as
DTMF issues may arise with voice
mail. 0
07 Enabled On-
Hook When
Holding (SLT) 0 = No
1 = Yes 1 11-12-45
08 Answer On-Hook
when Holding
(SLT) 0 = Disable (No)
1 = Yes (Enable) 1 11-12-46
ISSUE 3.01 SL1000/SL1100
Programming Manual 2-137
Program
15