NEC SIGMABLADE N8406-017, Manual

Page: 69 / 95

60
Removing the card
Follow the steps below to remove the card:
1. If any interface cables are connected to the card, remove them.
2. Open the ejector. When you open the
ejector, press the stopper securing the
ejector rightward.
Check
Fully open the ejector until it
stops.
3.
Hold the ejector and pull the card out of
the Blade Enclosure until you can hold the
card frame with both of your hands
(approximately 10 cm).
4.
Important
Do not hold the ejector. Otherwise the
ejector might be distorted, damaging the
card.
4. Firmly grip both sides of the card frame to remove the card from the Blade Enclosure.
If you want to use the system with the card removed, attach a slot cover.
5. Close the ejector of the card.
(1)
(2)