Installing Options 4-65
6.
Insert the new hard drive into the drive cage. Orient the
cable connectors toward the front of the drive cage. The
front wall of the drive cage has cutaways for the cables.
7.
Secure the drive in the drive cage with the four screws
that came with the device or the screws from the old
device.
8.
Replace the drive cage in the chassis (see “Replacing the
Drive Cage”).
9.
Connect the device cables (see “IDE Device Cabling” or
“Internal SCSI Device Cabling”).
10.
Replace the left cover of the system unit (see “Replacing
the Side Covers”).
11.
Run the Setup program to set your new configuration (see
“BIOS Setup Utility” in Chapter 3).
Removing the Drive Cage
Remove the drive cage by following these steps:
1.
Label and disconnect all cables connected to devices in
the drive cage.
2.
Remove the three screws securing the drive cage to the
rear of the chassis.