5-12 Setting System Board Jumpers
10.
If you removed any expansion boards, replace them
(see “Replacing Expansion Boards” in Chapter 3).
11.
Replace the system unit cover.
12.
Power on the system.
13.
Run Setup to set a new password (see Chapter 4,
“Setting System Parameters”).
PCI EXPANSION SLOTS
The following jumpers are set for your system in
manufacturing. These jumpers set the number of PCI slots
available to you. Use the information in the following figure
for verification purposes only.
1.
Power off and unplug the system and any peripherals.
!
WARNING
The system power must be off before removing the
cover and changing a jumper setting.
2.
Remove the system unit cover (see “Removing the
System Unit Cover” in Chapter 3).
3.
Locate the PCI Slot jumper J4G1 on the system board
(see the figure “Locating system configuration jumpers”
earlier in the chapter).
You may have to remove any installed expansion boards
to access the jumpers (see “Removing Expansion
Boards” in Chapter 3).
4.
Move the jumper to the number of PCI slots you want
enabled.
