5-8 Setting System Board Jumpers
4.
Move the jumper block to the Clear position.
Clear CMOS jumper settings
5.
Replace the system unit cover (“Replacing the System
Unit Cover” in Chapter 3).
6.
Connect system power cables and monitor.
7.
Power on the system. The system displays a system
configuration error message.
8.
Power off, unplug the system and monitor, and remove
the cover.
9.
Return the jumper block to the Normal Operation
position.
10.
If you removed any expansion boards, replace them
(see “Replacing Expansion Boards” in Chapter 3).
11.
Replace the system unit cover. Reconnect the system
power cables and peripheral devices.
12.
Power on the system.
13.
Run Setup (see Chapter 4, “Setting System
Parameters”).
CMOS Clear
−
J1K2
Normal Operation (Default)
Jumper 4-5
Clear
Jumper 5-6
1 3 1
A B
4
6 4
1 3 1
A B
4
6 4
