Setting System Board Jumpers 5-11
2.
Remove the system unit cover (“Removing the System
Unit Cover” in Chapter 3).
3.
Locate the Password Clear jumper J1K2 (A) on the
system board (see the figure “Locating system
configuration jumpers” earlier in the chapter).
You may have to remove any installed expansion
boards to access the jumpers (see “Removing
Expansion Boards” in Chapter 3).
4.
Move the jumper block to the Password Clear position.
Clear Password jumper settings
5.
Replace the system unit cover (see “Replacing the
System Unit Cover” in Chapter 3).
6.
Connect system power cables and monitor.
7.
Power on the system. The system lets you boot your
computer.
8.
Power off, unplug the system and monitor, and remove
the cover.
9.
Return the jumper block to the Password Enabled
position.
Password Clear
−
J1K2
Password Enabled (Default)
Jumper 1-2 (A)
Password Clear
Jumper 2-3 (A)
1 3 1
A B
4
6 4
1 3 1
A B
4
6 4