CHAPTER 2 HARDWARE INSTALLATION
User’s Manual U17307EJ2V0UM
13
Target cable connector:
Used to connect the connector of the target cable.
USB connector:
Used to connect the USB cable to be connected to the host machine.
Power LED:
Turned on in green when the FPL2 is connected to the host machine.
Status LED:
Blinks in red when the FPL2 is communicating with the target device.
MODE switch:
Switches power to be supplied to the target system.
Target: Used to supply V
DD
from the target system.
3 V:
Used to supply power to the target system with 3.0 V V
DD
from
the FPL2.
Caution When the Status LED is blinking, communication with the target device is in progress. Do not
disconnect the target cable and USB cable.
2.3.2 FPL2-FA
connector
Figure 2-3. Layout Drawing of FPL2 Connectors
Target connector: Used to connect the tip of the target cable.
FP4 connector:
Used to connect the FA adapter board or target system.
2.3.3 Target
system
The target system must be equipped with a device interface that complies with the target cable specifications.
Refer to
CHAPTER 6 CONNECTORS AND CABLES
for details.
2.3.4 USB
connector
The shape of the USB connector is a Mini-B type.
Refer to
CHAPTER 6 CONNECTORS AND CABLES
for details.
2.3.5 Target
cable
The tip of the target cable can be connected to the header pin that is 0.635 mm by 0.635 mm.
Refer to
CHAPTER 6 CONNECTORS AND CABLES
for details.
Target connector
FP4 connector
Component side (front)
Soldering side (rear)
