NEC PG-FPL, User Manual

Page: 67 / 102

67 Preliminary User’s Manual U17271EE1V0UM00
Chapter 5 Example of Use
This chapter explains a series of basic operations of the PG-FPL with the GUI software, taking a case
where the µPD70F3266 is used as the target device as an example. This chapter covers how to start
the system, execute the EPV command, and program the target device.
For the other commands and applications, refer to Chapter 4
Using The GUI Software.
Series of operations described in this chapter
The conditions of the series of operations described in this chapter are as follows:
Target system
Target device
: µPD70F3266
Clock : 5 MHz
Voltage level : 3.3 V
Communication : UART CH0
FPL
Parameter file
: 70F3266_CSI0.PRM
Clock setting : 5 MHz Multiplied by 4
Port : COM2 (38400 bps)
MODE switch : 2 (V
DD
: 3.3, V
DD2
: N.C)
Operation mode : Chip
Write HEX : FPL_TEST.HEX
Option setting :
•
Read verify after Program
•
Blank check before Erase
(1) Installing the GUI software
Install the FPL GUI software in the host machine you are using, by referring to
Chapter 3
Software Installation (if the software has not been installed yet).
(2) Installing the driver
Install the USB driver in the host machine you are using, by referring to
Chapter 3
Software Installation (if the driver has not been installed yet).
(3) Installing the parameter file
Copy the parameter file for the µPD70F3266 to the hard disk and install it in
<FPL-install-path>\PRM.
Download the parameter file from the following:
http://www.ee.nec.de/update