NS170 User Guide - Upgrading Your Server
4 - 34
SCSI Controller
Take the following into consideration either when installing an SCSI controller or when
using SCSI hard disk drives as internal hard disk drives. Refer to the manual that comes
with the SCSI controller for details.
■
Prepare the hard disk drives (up to 4 drives) and cables appropriate to SCSI
controller to be installed.
■
Configure the Logical Settings of hard disk drive.
■
When the controller is choosed to boot on OS, install the hard disk controller in the
highest priority PCI slot, i.e. in the smallest PCI slot number.
To indicate the global disk access status of drives connected to the SCSI controller with
the DISK ACCESS lamp on the front panel of the server, use the LED cable that comes
with your server to connect the LED connector (A) on the mother board and SCSI
controller.
Figure 4 - 30 : LED Connector
Figure 4 - 31 : LED Cable
LED Cable end A goes to motherboard, red wire towards the inside of the motherboard
(see picture above).
LED Cable end B goes to the RAID controller.
A
A
B
