71
6. Using On-Screen Menu
[OPTIONS(1)]
Enabling or Disabling Auto Focus [AUTO FOCUS]
This option turns on or off the AUTO FOCUS feature. (
→
)
NOTE:
When the “AUTO FOCUS” is on, the AUTO FOCUS function works instantly under the following conditions:
When you turn on the power.
•
When you change the zoom.
•
When you reposition the projector.
•
When you change the projection angle.
•
Selecting Fan Mode [FAN MODE]
This option allows you to select three modes for fan speed: Auto mode, High speed mode, and High Altitude
mode.
AUTO
��������������������� The built-in fans automatically run at a variable speed according to the internal temperature�
HIGH
���������������������� The built-in fans run at high speed�
HIGH ALTITUDE
���� The built-in fans run at a high speed� Select this option when using the projector at altitudes approxi-
mately 5000 feet/1500 meters or higher�
When you wish to cool down the temperature inside the projector quickly, select [HIGH].
NOTE:
• It is recommended that you select High speed mode if you use the projector non-stop for consecutive days.
• Set [FAN MODE] to [HIGH ALTITUDE] when using the projector at altitudes approximately 5000 feet/1500 meters or higher.
• Using the projector at altitudes approximately 5000 feet/1500 meters or higher without setting to [HIGH ALTITUDE] can cause
the projector to overheat and the protector could shut down. If this happens, wait a couple minutes and turn on the projector.
• Using the projector at altitudes less than approximately 5000 feet/1500 meters and setting to [HIGH ALTITUDE] can cause the
lamp to overcool, causing the image to flicker. Switch [FAN MODE] to [AUTO].
• Using the projector at altitudes approximately 5000 feet/1500 meters or higher can shorten the life of optical components
such as the lamp.
• Your setting will not be affected even when [RESET] is done from the menu.
Selecting [COLOR SYSTEM]
This feature enables you to select video standards manually.
Normally select [AUTO]. Select the video standard from the pulldown menu. This must be done for VIDEO and S-
VIDEO Connectors separately.
TIP:
The projector automatically detects a component signal.
