Single Mounting Point Installation
Mounting
Point
Security
Wrench
1/4 - 20 x 5/16”
Security Screw
If your projector has only one mounting point, a ¼-20 x
5/16” screw must be used to attach the mount to the
projector. Please refer to the following three steps:
Step 1.
Determine where the mounting point is located.
Step 2.
Place the projector plate over the mounting point.
Step 3.
Insert the ¼-20 x 5/16” security screw.
This screw will use a standard hole when mounting.
Ceiling Installation
Solid Surface Installation
Ceiling
Plate
Concrete Wedge
Anchor
Use a 1/8” drill bit to drill into the center of the
stud before securing the supplied wood screws.
The NOVA-EXT must be mounted to a
ceiling with a minimum 6” thickness. Use
concrete wedge anchors for concrete
installation. A masonry bit must be used to
drill the pilot hole.
Step 1.
Use two (2) #14 x 2” wood screws (supplied) to attach
the ceiling plate to a wooden ceiling stud.
Step 1
. Begin by placing the ceiling plate into position against
the ceiling, keeping it level.
Step 2
. Mark off four holes to be used for securing the mount
and place the ceiling plate aside.
Step 3.
Next, drill holes using the appropriate masonry bit for
your
anchor.
Step 4.
Insert a concrete anchor into each hole.
Step 5
. If necessary, a hammer can be used to lightly tap each
anchor into place so that they are flush with the ceiling.
Step 6.
Once all of the anchors are in place, move the ceiling
plate back into position.
Step 7.
Attach the nut onto the threaded shaft that is protruding
from the ceiling.
Step 8.
Do not tighten until all nuts are in place.
Installation Manual
Page - 7 -
