NEC NEAX IPS, Installation Manual

Page: 89 / 180

CHAPTER 3 BASICOPERATIONS AND VARIOUS EXPLANATIONS
– 79 –
NWA-008869-001 Rev.1.0
atch3001.fm
MEMO:
Besides the modes mentioned above, the router also provides boot monitor mode. The router
never enters this mode during normal operation; use this mode to maintain the In-Skin Router
in the event of a fault or emergency.
Changing the In-Skin Router between operation and config modes
From operation mode to config mode
To change the In-Skin Router from operation mode to config mode, use the enable-config command. Upon
entering config mode, the In-Skin Router shows a different prompt.
MEMO: When the In-Skin Router changes from operation mode to config mode for the first time, it enters
global config mode. If, after the In-Skin Router changed from config mode to operation mode,
you enter the enable-config command, the In-Skin Router enters the immediately preceding
config mode (global, interface, or device).
NOTE: You cannot change the In-Skin Router directly from operation mode to interface config or de-
vice config mode.
From config mode to operation mode
To change the In-Skin Router from config mode to operation mode, press [Ctrl] + [z].
Router # enable
−
config
Router (config) #
Enter
Router # enable
−
config
Router (config
−
Ethernet0.0) #
Enter
Router (config) #
Router #
Ctrl z +
MODES