NEC NEAX IPS, Installation Manual

Page: 139 / 180

CHAPTER 5 EXAMPLES OF SETUP ON NETWORKS
– 129 –
NWA-008869-001 Rev.1.0
atch5001.fm
Setting for router B
Setting the route
As the default route, use Serial0.0. Perform this on both routers A and B.
Setting DTI card
When originating a call from legacy terminal (single line telephone/D
term
) to a digital private network (T1)
via PZ-M649 card, the PN-24DTA-C (DTI) card is required. For the setting of DTI card, do the office data
programming for Direct Digital Interface (Refer to the Feature Programming Manual).
NOTE: The time slot number of both PN-RTA card side (PZ-M649 card) and PN-24DTA-C card side
have to be the same. Therefore, in the office data programming for Direct Digital Interface, as-
sign the same time slot number as PN-RTA card side by using CM07 Y=01.
For example, if the time slot number of PN-RTA card side is default setting (12 to 23), specify
12 to 23 for the channel number of PN-24DTA-C card in the data assignment of CM07 Y=01.
Router # enable
−
config
Router (config) # ppp profile router
−
b
Router (config
−
ppp
−
router
−
b) # no ipcp request
−
local
−
dns
Router (config
−
ppp
−
router
−
b) # exit
Router (config) # interface FastEthernet0.0
Router (config
−
FastEthernet0.0) # ip address 192.168.2.1/24
Router (config
−
FastEthernet0.0) # no shutdown
Router (config
−
FastEthernet0.0) # interface Serial0.0
Router (config
−
Serial0.0) # ppp binding router
−
b
Router (config
−
Serial0.0) # ip unnumbered FastEthernet0.0
Router (config
−
Serial0.0) # no shutdown
Router (config
−
Serial0.0) #
Enter
Enter
Enter
Enter
Enter
Enter
Enter
Enter
Enter
Enter
Enter
Router (config
−
FastEthernet0.0) # exit
Router (config) # ip route default Serial0.0
Router (config) #
Enter
Enter
DIGITAL PRIVATE LINE NETWORK EXAMPLE (T1)