NEC NEAX 2400 IPX, Programming Manual

Page: 140 / 316

CHAPTER 5 NDA-24305
Page 122
Revision 1.0
OUTGOING TRUNK QUEUING-PRI
STEP 3: ASPA - If System Data 2, Index 4, bit 0 is assigned for separate access codes, assign an access
code to OUTGOING TRUNK QUEUING assign, SRV
= SSC, SID = 19 and to OUTGOING TRUNK
QUEUING cancel, SRV = SSC, SID = 20. Assign SID
= 19 for a Connection Index of Busy and SID = 20 for a
Connection Index of Normal. If the access codes are the
same, either the access codes for OUTGOING TRUNK
QUEUING or the access codes for CALL BACK may
be assigned.
STEP 4: ASFC - Assign SFI1=1.
STEP 5: ARTD - Routes to be used for OUTGOING TRUNK QUEUING must be flagged in CDN 9, TQ.
Trunk Queuing Service. Always allow queuing to the LCR (S) Dummy route.
STEP 6: AKYD - Set the following data to assign CALL BACK Key on a D
term
. KYI: 1 FKY: 5 (= CALL
BACK)