NEC NEAX 2400 IPX, Programming Manual

Page: 113 / 316

NDA-24305 CHAPTER 5
Page 95
Revision 1.0
INTER-OFFICE OFF-HOOK QUEUING-PRI
3. Programming
STEP 1: ASYD - System Data 1, Index 42, bit 7: This bit must be assigned as data “0”, continuous
Service Set Tone.
STEP 2: ARTD - Assign the incoming TIE Line route.
<Example of 2 - WIRE E&M/4 - WIRE E&M>
<LCR (S) DUMMY ROUTE>
STEP 3: ARRC - Allow trunk-to-trunk connection between the incoming route and the outgoing route in
which INTER-OFFICE OFF-HOOK QUEUING will apply. Also allow trunk-to-trunk
connection between the incoming route and the LCR (S) dummy route. Assign both of
these for ARI: D. The outgoing route and the LCR (S) dummy route must be programmed
to allow OUTGOING TRUNK QUEUING [0-2]. Ensure that CDN 9, TQ = 1 (Trunk
Queuing) is set for that outgoing route.
RT : 2
1-OSGS :7/6 2-ONSG : 3 3-ISGS :7/6 4-INSG : 3 5-TF : 3
6-TCL : 4 7-L/T : 1 8-RLP : 2 15-LSG : 5 41-TDMQ : 1
Data other than the above should be set “0” (default data).
RT : 31
6-TCL : 4 7-L/T : 1 9-TQ : 1 13-AC : 1 41-TDMQ : 1
Data other than the above should be set “0” (default data).