4. Maintenance of Express5800/ft series
Express5800/R320d-E4, R320d-M4 Maintenance Guide (VMware 5.5)
38
Chapter 1 Maintenance
4. Run the following command to check the State shows "ONLINE" and Op State shows "DUPLEX" for
BMCs of I/O modules 0 and 1.
# /opt/ft/bin/ftsmaint ls 10/120
H/W Path
: 10/120
...
State
: ONLINE
Op State
: DUPLEX
......
# /opt/ft/bin/ftsmaint ls 11/120
H/W Path
: 11/120
...
State
: ONLINE
Op State
: DUPLEX
......
5. Run the following command to update BMC firmware. For
bmc_file
, specify the file path you have copied
in Step 2.
It takes approximately 30 minutes until update completes.
# /opt/ft/bin/ftsmaint burnBmcs bmc_file
When the following messages are displayed, update completes.
Updated firmware on the device at path 11/120.
Updated firmware on the device at path 10/120.
Important Do not operate the machine and power supply unit while the firmware is updated.
The firmware is destroyed and modules may need to be replaced.
6. Run the following command to check that Op State of BMC shows "DUPLEX" and Firmware Rev shows
the new BMC version.
# /opt/ft/bin/ftsmaint ls 10/120
Op State
: DUPLEX
:
Firmware Rev
: 03.18/00.09/03.03
Version is indicated in the underlined part.
# /opt/ft/bin/ftsmaint ls 11/120
Op State
: DUPLEX
:
Firmware Rev
: 03.18/00.09/03.03
Version is indicated in the underlined part.
7. Run the following command to check that Op State of I/O module shows "DUPLEX".
# /opt/ft/bin/ftsmaint ls 10
:
Op State
: DUPLEX
# /opt/ft/bin/ftsmaint ls 11
:
Op State
: DUPLEX
8. Unmount ft control software Install DVD, if mounted. Then, disconnect the DVD drive.
