5> Select “Configure Boot Devices” to display the Boot device’s settings window.
Emulex LightPulse FC BIOS Utility. KA6.01a12
01: LPe16002B-M6-N Bus#: 02 Dev#: 00 Func#: 01
Mem Base: FE700000 Firmware Version 1.1.35.0 BIOS: Disabled
Port Name: 10000090FA21129 Node Name: 20000090FA21129
Link Status: Link UP
List of saved Boot Devices:
1. Unused DID:000000 WWPN:00000000 00000000 LUN:00 Primary Boot
2. Unused DID:000000 WWPN:00000000 00000000 LUN:00
3. Unused DID:000000 WWPN:00000000 00000000 LUN:00
4. Unused DID:000000 WWPN:00000000 00000000 LUN:00
5. Unused DID:000000 WWPN:00000000 00000000 LUN:00
6. Unused DID:000000 WWPN:00000000 00000000 LUN:00
7. Unused DID:000000 WWPN:00000000 00000000 LUN:00
8. Unused DID:000000 WWPN:00000000 00000000 LUN:00
<
↑
/
↓
> to Highlight, <Enter> to Select
Copyright (c) 1997-2012 Emulex. All rights reserved.
If no Boot device can be detected from this product you selected above, you will
see a message, “This Adapter is not ready, try again!” If you selected a wrong
number in the above step, press <ESC> key to return to the previous window and
select the correct one.
If you have selected the correct figure, confirm that the Fibre Channel device is
properly connected and its settings are all correct. Then, reboot the compuetr
and try these steps from the beginning.
6> Select an entry number to register the Boot device. Then, you see the window to select a device.
Emulex LightPulse FC BIOS Utility. KA6.01a12
01: LPe16002B-M6-N Bus#: 02 Dev#: 00 Func#: 01
Mem Base: FE700000 Firmware Version 1.1.35.0 BIOS: Disabled
Port Name: 10000090FA21129 Node Name: 20000090FA21129
Link Status: Link UP
00. Clear selected boot entry!!
01. ALPA:B3(7D) WWPN:21000016 97122446 LUN:00 NEC DISK ARRAY 1000
Enter <Esc> to exit <PageDn> to Next Page
<
↑
/
↓
> to Highlight, <Enter> to Select
Copyright (c) 1997-2012 Emulex. All rights reserved.
Notice
- 55 -
