(1) PCI Express connector
Connector to be inserted into the PCI slot of the computer.
This product’s PCI Express connector type is x8.
(2) Bracket
Bracket to fix this product to the extended slot of Computer.
When fixing this product to a PCI slot optimized for the low profile type, replace the
bracket with the attached low profile one.
(3) SFP+ Module
Module to transmit and receive Fibre Channel signals. Need to remove temporarily when exchange a
bracket or install this product into computer.
Don’t insert the SFP+ module of this product to the other N8190-7158 or the other
Fibre Channel device.
(4) LED (Port0/Port1)
Two LED for each port (Port0/Port1) give a visual indication of the operating state.
The slow blink rate is 1Hz; the flashing state is an irregular on/off appearance reflecting program
activity.
Green LED
Yellow LED
State
Off
Off
Boot Failure (Dead Board)
Off
On
POST Failure (Dead Board)
Off
Slow Blink
Boot Failure after POST
Off
Flashing
POST Processing in Progress
On
Off
Failure While Functioning
On
On
Failure While Functioning
On
Blink(3 beat)
8Gbps Link Rate – Normal, link up
On
Blink(4 beat)
16Gbps Link Rate – Normal, link up
Slow Blink
Off
Normal – Link Down
If the product fails at POST, please check the following items.
- Is the product installed in the computer correctly?
- Are all Fibre Channel cables and power cords connected correctly?
(5) Fibre Channel Connector (Port0/Port1)
Connector (LC Connector) used to connect this product to a Fibre Channel device.
Do not remove dust cover when not connected to Fibre Channel device.
(7)IEEE Address
IEEE Address of Port0 is displayed by this label.
The IEEE address of Port1 is the next successive number of the Port 0.
The IEEE address correspond to the lower 12 figures of Worldwide Name(WWN)
address.
Tips
Tips
Tips
Notice
Notice
- 41 -
