76
Phenomenon
Cause
Action
The busy indicator is
illuminating.
Press the eject button after the busy indicator goes
off.
Pressing the
eject button
does not
allow the
tray to be
ejected.
The function of the eject
button is restricted by the
usage environment (including
the computer, operating
system, and device driver)
Depending on the environment in which the Built-in
DVD-RAM drive is used, pressing the eject button
cannot have the disk ejected. Refer to the relevant
manual to eject the disk in the way following the
procedure. (The disk may not be ejected due to the
occurrence of an error in the computer. If so, turn off
the power of the computer and then eject the disk
according to the manual eject procedure.)
A disk having been used in
another computer or
operating system is set to the
Built-in DVD-RAM drive.
It is impossible to use a disk into which data is written
by another device or that of the format type unsuitable
to the environment in which the Built-in DVD-RAM
drive is used. Use any of the disks fit to the
specifications and environments of the Built-in DVD-
RAM drive and the computer.
The Built-in DVD-RAM drive
was subject to a rapid
temperature change.
The disk, the Built-in DVD-RAM drive, and/or the
computer may be condensed due to a rapid
temperature change. If a rapid temperature change
occurs, wait for an hour or longer before using the
system.
Data read is
disabled.
The disk is dirty.
Clean the disk.
The disk is write-protected.
Release the write protect of the disk.
Data write is
disabled.
The disk is not formatted yet
or formatted in a format
which does not meet the
environment for the Built-in
DVD-RAM drive or the
computer.
Format the disk in the form suitable to the
environments of the Built-in DVD-RAM drive and the
computer. (If the data saved in the disk is required,
use another disk.)
The usage environment
temperature is too low.
At the operating environmental temperature of 5°C or
less, the Built-in DVD-RAM drive may be able to read
data from the disk but unable to write data to the disk.
Use the Built-in DVD-RAM drive after increasing the
operating environmental temperature to 5°C or
higher.
The Built-in DVD-RAM drive
was subject to a rapid
temperature change.
The rapid temperature change may cause the disk,
the Built-in DVD-RAM drive, and/or the computer to
be condensed. If a sudden temperature change
occurs, wait for an hour or longer before using the
system.
The disk or the read/write
head of the Built-in DVD-
RAM drive is dirty.
Clean the read/write head and the disk. If the writing
operation is disabled still, contact you service
representative.
The disk is now formatted
physically.
It took longer time for physical formatting than for
logical formatting. Wait for a while.
Much time is
taken for
disk
formatting.
The disk is dirt.
Clean the disk.
Summary of Contents for N8151-32B
Page 22: ...14 ...
Page 32: ...24 3 ディスクをトレーにのせる 4 イジェクトボタンを押してトレーを閉じる データ面をトレーに向け レーベルな どの印刷面を上に向ける ホルダーに引っかける ...
Page 63: ...55 ...
