Precautions iii
FCC Compliance Information Statement, Class B
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not
cause harmful interference, and (2) this device must accept any interference received, including interference that may cause
undesired operation.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the
FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined
by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following
measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and the receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for assistance.
Industry Canada Class B Emission Compliance Statement/
Avis de conformité à la réglementation d‘Industrie Canada
:
CAN ICES-3(B)/NMB-3(B)
KCC Notice Class B (Republic of Korea Only)
B급 기기
(가정용 방송통신기자재)
이 기기는 가정용
(B
급
)
전자파적합기기로서 주로 가정에서
사용하는 것을 목적으로 하며
,
모든 지역에서 사용할 수 있습니다
.
EU Contact:
NEC Nederland B.V.
Olympia 4, 1213 NT Hilversum, The Netherlands
Trademark, name and address of the manufacturer:
NVIDIA Corporation
2788 San Tomas Expressway, Santa Clara, CA 95051 USA
Summary of Contents for N8105-53
Page 2: ......
Page 21: ......
Page 36: ...J 16 PhysX 構成の設定 サポート外の機能です PhysX の設定をします ...
Page 61: ...E 15 PhysX configuration settings Unsupported Set up PhysX ...