![background image](http://html1.mh-extra.com/html/nec/n8100-2089f/n8100-2089f_user-manual_4252342095.webp)
1. Installing Internal Optional Devices
Express5800/T120e User’s Guide
95
Chapter 2 Preparations
6.
Attach the connector on the other end of the cable to the connector for attaching an extra RS-232C cable
connector on the motherboard.
7.
After attaching the connector, the COM port setting might need to be configured by using the BIOS
setup utility. An example of how to configure the COM port is shown below.
a) Turn on the server. Press the F2 key while the POST screen is displayed to launch the
BIOS setup utility.
b) Select
Advanced
, and then
Serial Port Configuration
. Make sure that
Serial Port B
is set to “Enabled”. (If not, set it so.)
By setting
Serial Port B
to “Enabled”, the
Base I/O
and
Interrupt
menus are
added. By default,
Base I/O
is set to “2F8h”, and
Interrupt
is set to “IRQ 3”.
1.12.6 Removal
To remove a PCI board, reverse the installation procedure.
Run SETUP and change boot order in Boot menu. Refer to
Chapter 3 (2. System BIOS Setup)
for how to
specify it.
If using the server while the board is removed, attach the blank cover that comes with the PCI slot.
Important Pay attention in case that the Internal cables are hooked on a chassis when
you removed the PCI board. If the cables are hooked the PCI board may be
damaged.