1. Installing Internal Optional Devices
Express5800/T110f-S User’s Guide
92
Chapter 2 Preparations
•
Connecting a RAID controller (N8103-149) and an extra 2.5-inch HDD cage (N8154-56F)
When a RAID controller (N8103-149) is installed and an extra 2.5-inch HDD cage (N8154-56F) is
connected, dedicated cables (K410-277(00) and K410-287(00)) are required. Do not use the cable that
comes with the extra 2.5-inch HDD cage (N8154-56F).
Install the hard disk drives sequentially starting from the leftmost slot when viewed from the front.
•
About RAID LED cables
The DISK access LED on the front of the equipment shows the access status of hard disk drives that are
connected to a RAID controller. To display this status, connect the LED cable that comes with the optional
cable K410-277(00).
Connect the LED connector on the motherboard to the connector on the RAID controller.
See the figures below and connect the LED cable to the LED connector of the motherboard.
SATA4
HDD LED1
I-SAS5
I-SAS4
(4 to 7)
(0 to 3)
Power
supply unit
Motherboard
RAID controller
(
N8103-149/151
)
Slot 0: First Hard Disk Drive
Slot 1: Second Hard Disk Drive
3.5-inch HDD cage
(N8154-65F)
Extra battery
(N8103-155)
Optical disk drive
Slot 4: Third Hard Disk Drive
Slot 5: Fourth Hard Disk Drive
Extra 2.5-inch HDD cage
(N8154-56F)
Battery cable (included with the extra battery)
SATA cable (for the optical disk drive)
Internal SATA cable (K410-277 (00))
RAID LED cable (included with K410-277 (00))
Internal SAS/SATA cable (K410-287 (00))
Motherboard
LED connector
To the motherboard side
