2. System BIOS Setup
Express5800/T110f-S User’s Guide
112
Chapter 3 Setup
2.
System BIOS Setup
This section describes how to configure Basic Input Output System (BIOS).
2.1
Overview
The BIOS Setup Utility (SETUP) is a utility to configure basic hardware settings. This utility is pre-installed in
the server as standard and can run without bootable discs.
Usually, you do not need to change the parameters of the SETUP.
Use only when the case applies to any
of cases described in Chapter 3 (2.4 Cases that Require Setting Changes)
.
2.2
Starting SETUP Utility
Turn on the server and wait until the following message appears. See
Chapter 3 (1.1.1 POST sequence)
for
details.
Press <F2> SETUP, <F3> Internal Flash Memory, <F4> ROM Utility, <F12> Network
When you press <F2> key during displaying the message or the NEC logo, SETUP runs and displays the
Main
menu upon completion of POST.
About password entry
The entry of the password appears after you set a password in SETUP.
Enter password [ ]
If you enter a wrong password three times, SETUP stops.
Turn off the server and try again.
To exit SETUP after saving the parameters, choose
Save & Exit
and then
Save Changes and Exit
.
To exit SETUP without saving the parameters, select
Save & Exit
and then
Discard Changes and Exit
.
