English-7
OSD (On-Screen-Display) Controls
Channel Search
When powering on for the fi rst time, you will be prompted to scan and memorize all available channels
from your RF input signal. To start this process, press the “OPTION” button to display the TV OSD
menu.
NOTE: Analog channels are indicated with a -0 following the channel number. Digital channels are indicated with a – followed by a number.
For example, channel 2-0 is analog and channel 2-1 is digital. Analog channels may also have separate digital sub channels
associated with them for example channel 3-0 would be analog followed by channel 3-1, 3-2, etc.
NOTE: When Channel Lock function is “On”, the Channel Search cannot be used.
If Channel Lock is “On”, set it to “Off” before proceeding.
Auto Scan
Depending upon the RF input signal, you will need to scan for either off air (antenna) or cable channels.
Off Air Scan
1. On the “Tuner” menu page, press
button to select
“Channel Search” and press the “SET” button. There are
two sub-menus listed.
(1) Auto Scan
(2) Manual Scan
2. Select “Auto Scan” and press the “SET” button.
3. Select “Off Air” and press the “SET” button.
4. Press
button and “SET” button to select the TV System,
ATSC (digital) and NTSC (analog). Then select ”Scan” and
press the “SET” button to start channel scanning.
• It takes several minutes to complete the scanning process; the percentage bar displays the progress.
5. When the scan has complete, press the “OPTION” or “EXIT” button to leave this window. Press the “CH+”
and “CH-“ buttons to verify the channels are found and memorized.
Cable Auto Scan
1. Follow steps 1~2 listed above to activate the “Auto Scan”
function for cable signals.
2. Select “Cable” and press the “SET” button.
3. Press
button and the “SET” button to select “Cable
Type”. Select “STD”, “IRC” or “HRC” then press the “SET”
button.
NOTE: STD, IRC and HRC indentify various types of cable TV systems. Contact
your local cable company for the type of cable system that exists in your
particular area.
4. Press
button and “SET” button to select the TV System, NTSC (analog) and QAM (digital). Then
select ”Scan” and press the “SET” button to start channel scanning.
• It takes several minutes to complete the wholes scanning process; the percentage bar displays the
progress.
5. When the scan has completed, press the “OPTION” or “EXIT” button to leave this window. Press the
“CH+” and “CH-“ buttons to verify the channels found and memorized.
