NEC LS2400, User Manual, Page: 117 / 186

Problem Solving 5-13
CD-ROM Drive Activity Light Does Not Light
Check the following:
!
Is the power and signal cable to the CD-ROM drive properly installed?
!
Are all relevant switches and jumpers on the drive set correctly?
!
Is the drive properly configured?
!
Is the onboard IDE controller enabled?
Note: Front panel hard disk LED indicates IDE and SCSI
devices
: The hard disk drive activity light on the front panel lights
when either an IDE hard disk drive, or a SCSI device controlled by
the onboard SCSI host controller, is in use. This LED does not
display
CD-ROM activity.
Problems with Application Software
If you have problems with application software, perform the following:
!
Verify that the software is properly configured for the system. Refer to the
software installation and operation documentation for instructions on
setting up and using the software.
!
Verify a different copy of the software to see if the problem is with the copy
that you are using.
!
Make sure all cables are installed correctly.
!
Verify that the system board jumpers are set correctly. Refer to the
“Configuring Your System” chapter for jumper settings.
!
If other software runs correctly on the system, contact your vendor about
the failing software.
If the problem persists, contact the software vendor's customer service
representative for assistance.
Press F2 Key to Enter Setup: Prompt Does Not Display
If the prompt “Press F2 key to run Setup” does not appear at system startup,
then the prompt option has been disabled in the SSU. There are two ways to
enable the prompt:
!
Reboot the system using your SSU diskette, and go into the SSU to enable
the prompt.
!
Clear CMOS memory by changing a jumper, and go into the SSU to enable
the prompt.