NEC LS2400, User Manual, Page: 103 / 186

Upgrading Your System 4-31
Note:
If the drive comes with drive rails, do not use them.
Remove any rails already attached.
5. Slide the drive into the bay until the screw holes line up. It may be
necessary to temporarily loosen the mounting screws on the already
installed drives to position the new drive. Secure the drive to the bay
with the four supplied screws.
Installing a Removable Media Device
6. Connect the signal and power cables to the drive as shown in Figure
5-15. All device power cables are labeled and must be installed in
specific locations as shown below:
Drive Location Power Connector
A
B (Tape) P5
C (CD-ROM) P3
D (Diskette) P6
7. Replace the front panel and side panels, and power on the system.
5.25" Drive
Power Cable