![background image](http://html1.mh-extra.com/html/nec/ip3na-bch/ip3na-bch_user-manual_3915388006.webp)
iv
FCC portion
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses, and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the interference by
one or more of the following measures:
!
Reorient or relocate the receiving antenna.
!
Increase the separation between the equipment and receiver.
!
Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
!
Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) This device may not cause harmful interference, and (2) This device must
accept any interference received, including interference that may cause undesired operation.
Caution:
Any changes or modifications not expressly approved by the party responsible for product
compliance could void the user’s authority to operate the equipment.
To comply with FCC RF exposure compliance requirements, this device must not be co-
located or operating in conjunction with any other antenna or transmitter.
RF Exposure Guidelines
LO(BTC)B / LO(BTC)U
To comply with FCC RF exposure compliance requirements, a separation distance of at least
20 cm must be maintained between the antenna of this device and all persons. This device
must not be co-located or operating in conjunction with any other antenna or transmitter.
LO(BTH)B / LO(BTH)U
To comply with FCC RF exposure compliance requirements, this device must not be colo-
cated or operating in conjunction with any other antenna or transmitter.
LO(BTH)B or LO(BTH)U was tested with BELTCLIP(BTH)(BK).Use only
this beltclip to ensure FCC Compliance. The use of third-party beltclips may not comply with
FCC RF exposure compliance requirements, and should be avoided.