NEC IE-784915-R-EM1, User Manual

Page: 17 / 65

17
CHAPTER 1 GENERAL DESCRIPTION
1.4 Target Device
The following products are the target devices that can be emulated by the IE-784000-R and IE-784000-R-EM in
combination with the IE-784915-R-EM1.
<
µ
PD784915 subseries> <
µ
PD784928 subseries> <
µ
PD784928Y subseries>
•
µ
PD784915 •
µ
PD784927 •
µ
PD784927Y
•
µ
PD78P4916 •
µ
PD784928 •
µ
PD784928Y
•
µ
PD78F4928 •
µ
PD78F4928Y
Remark The
µ
PD784928 subseries and 784928Y subseries are under development.
1.5 Emulation Probe
Use of the IE-784915-R-EM1 connected to the target system always requires an emulation probe. The emulation
probe is available separately.
Part Number Target Package
EP-784915GF-R 100-pin plastic QFP (14
×
20 mm)
Caution Two types of probe tip board (dummy board) are provided: LCC type and QFP type. See VOLUME
2 EP-784915GF-R for details.
1.6 Operating Precautions
(1) Be sure to turn off the power of the IE-784000-R and target system before connection of the IE-784915-R-
EM1 with the IE-784000-R and IE-784000-R-EM and its removal.
(2) When performing emulation of the target device by the IE-784915-R-EM1 in combination with the IE-784000-
R and IE-784000-R-EM, note that there are partial differences in pin characteristics from the real chip (see
CHAPTER 5 DIFFERENCES FROM TARGET DEVICE).
(3) Correctly attach the IE-784915-R-EM1 to the IE-784000-R-EM.
(4) Correctly attach the IE-784000-R-EM to the IE-784000-R main unit.
(5) Correctly connect the chip set board.
• When an emulation probe is used,
→
connect the chip set board to the tip of the emulation probe.
• When an emulation probe is not used,
→
connect the chip select board to connectors L1 and L2 of the IE-784915-R-EM1.
Caution Do not simultaneously connect the chip set board to both the tip of the emulation probe and the
IE-784915-R-EM1.