© NEC Corporation 2019 41
6.2
Install Power Bar onto Frame Supports
This section is a guide to mounting the Power bar onto the frame supports and describes the
following in more detail:
Prepare the frame supports so they are level.
Position the Power bar on the frame supports.
Then fix the Power bar onto the frame supports.
Table 9: Power Bar Installation Requirements
No. of People 2
Prerequisites
Frame support securely installed
Power bar/LED Wall not connected to mains
Tools
Alignment bar
Spirit level
Screwdriver
Equipment
Power bar
Check the Evenness
Use the Alignment bar and spirit level in combination to check the evenness between
the vertical frame supports.
If necessary, adjust top and bottom supports accordingly.
Bring Power Bar into Position
Bring the Power bar into position to align interface to anchoring point.
Align the locating pin of the Power bar to the frame support interface.
Figure 47: Wall Mounting: Attachment of Power Bar (5×5 Frameset)
Attach Power Bar to Frame Supports
Use M6×12 Screws (4 per frame support) to
attach Power bar onto the frame supports.
Check that the Power bar is level. If
necessary, adjust accordingly.
Tighten the screws.
Figure 48: Wall Mounting: Attachment of Power Bar (Detail)
