NEC Express5800/AT101a, User Manual, Page: 36 / 108

2-10 General Description
STATUS lamp
The STATUS lamp stays lit in green when the Tape Blade is in successful operation. When the STATUS
lamp is flashing in amber or red, it indicates that the system has failed.
In addition, you can view the detailed information on error message on virtual LCD when the STATUS
lamp is flashing in amber or red. You can use the virtual LCD through the Web console of Blade Enclosure.
See Chapter 8 for indication on virtual LCD, descriptions, and actions to take. If an error occurs, contact
your service representative.
The following tables list indications of the STATUS lamp, descriptions, and actions to take.
NOTE:
The Tape Blade does not support EXPRESSSCOPE Engine (BMC).
You cannot view the error log through NEC ESMPRO Manager.
STATUS lamp indications
STATUS lamp
Status Color
Description Action
On Green The Tape Blade is operating
normally.
–
Off –
The power is turned off.
Turn on the power.
On Red BMC is being initialized.
1. Wait until the lamp goes off.
2. If the lamp still goes on, check
installation of the Tape Blade.
Flash Red See the table "Virtual LCD indications when STATUS lamp is flashing in
red" described in Chapter 8.
Flash Amber See the table "Virtual LCD indications when STATUS lamp is flashing in
amber" described in Chapter 8.
NOTE:
If the Tape Blade is powered off while the STATUS lamp is flashing
in amber or red, the indication of the STATUS lamp is retained except for
certain factors. When the Tape Blade is powered on, the STATUS lamp goes
on green (normal status).