![background image](http://html.mh-extra.com/html/nec/express5800-120rg-2/express5800-120rg-2_user-manual_251210288.webp)
9-48 Upgrading Your Server
13.
Connect the interface cable and power cable to the backplane as shown in figure below.
NOTE:
Confirm where to place the terminator at the end of the SCSI
cable. The terminator must be placed in the device bay. At this time,
also confirm that the SCSI cable is not in contact with the latching tab
of the device carrier. This is to prevent the cable from being damaged.
14.
Insert the device carrier into the device bay until it locks.
15.
Route the SCSI cable as shown in figure below. (SCSI device only)
<IDE device>
Optical SCSI cable
(K410-130 00)
SCSI backplane connector for
backup device
SCSI Ch.A
<SCSI device>
SCSI Connector
Summary of Contents for Express5800/120Rg-2
