![background image](http://html.mh-extra.com/html/nec/express5800-120rg-2/express5800-120rg-2_user-manual_251210247.webp)
Upgrading Your Server 9-7
Installation
Take the following steps to install a hard disk drive. This procedure applies to all the hard disk drive
bays.
NOTE:
Any hard disk can be installed or removed in or from the server
only by removing the front bezel.
IMPORTANT:
In the disk array configuration, use the hard disks
having the same specification including the capacity.
1.
See the section "Preparing for Installation and Removal" described earlier to prepare.
2.
Unlock the front bezel with the security key and remove the front bezel.
3.
Locate the slot in which you are going to install a hard disk drive.
The server has six slots. Install hard disk drives in ascending order of the SCSI ID
numbers. The SCSI IDs assigned to the slots are all determined.
4.
Remove the dummy block.
IMPORTANT:
Keep the dummy block for future use.
5.
Unlock the lever of the hard disk drive carrier and open the handle.
Summary of Contents for Express5800/120Rg-2
