NEC DLP CINEMA NC1600C, Service Manual

Page: 133 / 382

“Confidential, Do Not Duplicate without written authorization from NEC.”
5-3
SERVICE MODE
3
Ref. Select
Used to select default setup for the motor-operated turret position when a title is established newly.
Example of display
Turret
Ref. Select
(*)
< Without Anamo.>
First line : Indication of "Turret"
Second line : Indication of "Ref. Select"
Third line
: Indication of current setup
Fourth line : For "Enable: "With Anamo"
For "Disable": "Without Anamo"
Ext. MMS Link
Enabled when External MM connection is made:
Proceed to connect again, connection cutoff commands
Used when the linkage with the MM is disconnected or disconnection is required.
Example of display
Setup
Ext. MMS Link
(*)
< Connect >
First line : Indication of "Setup"
Second line : Indication of "Ext. MMS Link"
Third line
: Indication of current setup
Fourth line : For "Enable: "Connect"
For "Disable": "Disconnect" (*1)
(*1) Linkage with the External MM is disconnected.
The status of disconnection is maintained until the next connection is made.
Panel Key Lock
Enable/Disable of the main unit control keys is set up.
Example of display
Setup
Panel Lock Key
(*)
< Lock >
First line : Indication of "Setup"
Second line : Indication of "Panel Key Lock"
Third line
: Indication of current setup
Fourth line : Panel key disabled: "Lock"
Panel key enabled: "Unlock"
(*) In the lock mode, canceling is possible by pressing the Cancel key for a long time (10 seconds).