3-8 Option Installation
Non-Error Correcting and Checking (64-bit) and ECC (72-bit) DIMMs are both
supported. When ECC memory is installed, the BIOS automatically detects its
presence and offers the Setup option to enable ECC mode.
NOTE:
Although memory size and type may
vary, the SDRAM DIMMs must meet the Intel
4-clock, 66-MHz, unbuffered SDRAM DIMM
specification for either 64-bit or 72-bit SDRAM.
Use the following procedure to:
Check the memory installed in the system
Determine the DIMM configuration needed to increase memory
Identify DIMM sockets.
NOTE:
If any cables block access to the DIMM
sockets, label and disconnect them. If any boards
block access to the sockets, remove them.
1.
Locate the three DIMM sockets, J7J1 – Bank 0, J6J2 – Bank1, and
J6J1 – Bank 2. See Appendix B to identify the sockets.
2.
Use the following table to determine the DIMM configuration needed to upgrade
memory.
Summary of Contents for Direction 233L
Page 9: ...x Contents ...
