Appendix A
System Specifications
This section describes the system specifications.
Processor
Microprocessor
233-MHz, 266-MHz, 300-MHz, or 333-MHz Pentium II MMX
Clock Rate
200 MHz internally, 66 MHz externally
233 MHz internally, 66 MHz externally
300 MHz internally, 66 MHz externally
333 MHz internally, 66 MHz externally
Processor Support
32-bit addressing
64-bit data
Primary Cache
32 KB of internal write-back cache on processor
Secondary Cache
512 KB of pipeline burst cache
Processor Mounting
Processor subsystem is inserted into slot 1 on the system board.
A 242-pin edge connector is implemented on the processor card for system board
installation.
Each end of slot 1 has a Retention Mechanism Attach Mount (RMAM) inserted
through the board. RMAM is made of two studs connected with a bridge.
Retension Mechanism (RM) is inserted over slot 1 to act as an insertion guide and
prevent movement of processor after subsystem mounting.
RM is attached to RMAM by 4 captive nuts held to the guide with fasteners.
For thermal protection, a heatsink is supported by a Heat Sink Support (HSS),
which is attached to the system board by two push pins.
The heatsink is secured in place to the HSS by an HSS top bar.
Summary of Contents for Direction 233L
Page 9: ...x Contents ...
