Neat INKA, Technical Handbook, Page: 17 / 36

INKA, IOR, REPO & LINK
2.2 Jumper Configuration
Some of the basic configuration parameters can be changed by mounting or removing jumpers on the
circuit board inside the unit. A configuration parameter is only affected by jumper settings if the
parameter is configured to “Use jumper(s)” in IOR Programmer.
By default, all parameters that can be configured by setting jumpers have the value “Use jumper(s)”
when the unit is delivered, unless something has been specified when the units were ordered.
The only exception is the
power mode , which by default has the value “No/Function off”, in other
words power save mode is disabled by default.
2.2.1 Jumper Settings – Overview
An overview of the jumper settings is given in the table below.
Jumper Product
Model
Description
INKA
IOR
Input mode for wired input 1, see section 2.2.2
J1
REPO
LINK
Receive all radio messages, see section 2.2.4
INKA
IOR
Input mode for wired input 2, see section 2.2.2
J2
REPO Maximum number of hops, see section 2.2.5
INKA
IOR
Input mode for wired input 3, see section 2.2.2
J3
REPO Maximum number of hops, see section 2.2.5
INKA
Input mode for wired input 4 and 5, see section
2.2.3
REPO Transmission delay, see section 2.2.6
J4
IOR
LINK
Output mode, see section 2.2.7
INKA
Input mode for wired input 4 and 5, see section
2.2.3
REPO Transmission delay, see section 2.2.6
J5
IOR
LINK
Output mode, see section 2.2.7
J6
INKA
IOR
Power mode, see section 2.2.8
Technical Handbook for the IOR Family (firmware v20.x), document number NE41 06007-02 v1.0
17