NDS Radiance Ultra SERIES, User Manual

Page: 7 / 50

Safety Information | iii
Safety Information
Warnings and Cautions
This symbol alerts the user that important information regarding the installation and/or operation of
this equipment follows. Information preceded by this symbol should be read carefully in order to avoid
damage to the equipment.
This symbol warns the user that un-insulated voltage within the unit may have sufficient magnitude to
cause electrical shock. It is dangerous to make contact with any part inside the unit. To reduce the risk of
electric shock, DO NOT remove cover (or back).
NOTE: There are no user serviceable parts inside. Refer servicing to qualified service personnel.
This symbol cautions the user that important information regarding the operation and/or maintenance
of this equipment has been included. Information preceded by this symbol should be read carefully to
avoid damage to the equipment.
This symbol denotes the manufacturer.
This symbol denotes the manufacturer’s European Community representative.
To prevent fire or shock hazards, do not expose this unit to rain or moisture. Also, do not use this unit's polarized
plug with an extension cord receptacle or other outlets unless the prongs can be fully inserted. The product is
designed to meet the medical safety requirements for a patient vicinity device.
This product is a Class I medical device according to M.D.D. in Europe. No modifications are allowed.
This equipment/system is intended for use by healthcare professionals only.
This product is intended for continuous operation.
Safety Compliance
This product is T.U.V. approved with respect to electric shock, fire and mechanical hazards only in accordance with
CAN/CSA C22.2 No. 60601-1 and ANSI/AAMI ES60601-1.
Safety Compliance
This device meets the requirements of EN60601-1 so as to conform to the Medical Device Directive 93/42/EEC and
2007/47/EC (general safety information).
This product complies to the above standards only when used with the supplied medical grade power supply:
Power Cord
Use a hospital grade power cord with the correct plug for your power source.
Disconnect the power cord from the AC mains. The power cord is the only recognized disconnect device.
MEDICAL EQUIPMENT should be positioned so that the disconnect device is readily accessible.
Monitors should be powered from a center tapped circuit when used in the US at voltages over 120 volts.
Grounding
This product is energized from an external electrical power source for Class 1 equipment. It is the responsibility of
the installer to test the product’s earth ground to verify that it complies with the hospital, local and national
impedance requirements.
A ground post is located on the back of the product to use for grounding the chassis of the unit. Any such ground
must be installed in accordance with applicable electrical codes. The ground post is shown in the mechanical
drawing found on page 21.
Model Radiance Ultra
Power Supply BridgePower BPM150S24F06
AC Input 100 - 240V, 50 - 60 Hz
DC Output 24V, 6.25A